Specification of decoration skills installation of

2022-07-22
  • Detail

When a rookie is decorating, he often asks workers to help install the toilet, and stands beside him as if he were a supervisor. In fact, he can't see anything

when a rookie decorates, he often asks workers to help install the toilet, and stands beside him as if he were a supervisor. In fact, he can't see anything. If workers cheat on work and materials, it will bring great inconvenience to future use

in fact, the installation process of the toilet is very critical, and the acceptance is also very particular. We can't just look at the final result. As long as we let the workers carry out the construction according to the specifications during the installation process, we can avoid bringing hidden dangers to future life. Now let's take a look at the standard installation process of toilet

(1) take out the pipe plug of the ground water outlet, check that there are no sundries in the pipe, and then clean the area around the pipe orifice

(2) align the outlet pipe orifice of the toilet with the outlet pipe orifice, lay it flat and align it, draw a mark on the bolt hole of the toilet, and remove the toilet

(3) punch a hole with a diameter of 20mm and a depth of 60mm at the mark, insert the bolt with a diameter of 10mm into the hole, twist it firmly with cement, align the toilet eye with the bolt, make it consistent with the mark, and remove the toilet after the test. Apply putty around the outlet of the toilet and the outlet of the sewer pipe, align the four bolt holes of the toilet with the bolts, lay them flat and align them, put rubber pads on the bolts, screw on the nuts, and tighten them to a proper tightness

(4) align the center of the rear tail of the toilet, draw a vertical line, draw a horizontal line at a height of 800 mm from the ground, draw a mark on the horizontal line according to the position of the two side holes on the back of the water tank, and punch a hole with a diameter of 30 mm and a depth of 70 mm at the hole. Insert a bolt with a diameter of 10mm and a length of 100mm into the hole and twist it firmly with cement. Hang the back water tank on the bolt, place it flat and align it, especially align it with the center of the toilet, put a rubber pad on the bolt, screw on the nut, and tighten it to a proper tightness

(5) when installing the water elbow of the back water tank, first remove the nuts of the water inlet of the back water tank and the water inlet of the toilet, cover it back-to-back on the water elbow, and cover the rubber pad on the water pipe respectively. Insert the upper end of the water elbow into the water inlet of the back water tank and the lower end into the water inlet of the toilet, then push the rubber pad to the water inlet, screw on the nut, align and straighten the water elbow, and screw it with pliers to a proper tightness

(6) when using the splay door to connect the water supply, first measure the size of the float door of the water tank from the water supply pipe opening, configure the short joint, install the splay door, and put it into the water supply pipe opening. Break the copper pipe or plastic pipe, bend the lamp fork properly, and then put the nuts of drift gate and splay gate back to back on the copper pipe or plastic pipe. Wrap the two ends of the pipe with oil asbestos rope or lead oil hemp thread, insert them into the inlet and outlet of drift gate and splay gate respectively, and tighten the nuts

成都耳鼻喉医院

石家庄胎记医院

重庆男科医院

Copyright © 2011 JIN SHI